FeverCheck.doc - WordPadケーススタディ
← Back to projects もどる
FeverCheck

FeverCheck

A breadboard circuit that reads temperature and humidity and flags fever-range readings on an LCD

Team

Solo project

My role

Hardware

Embedded Firmware

Tools

Arduino

DHT Sensor

16x2 LCD

Embedded C

Duration

Personal project

Overview

FeverCheck is an Arduino circuit that reads ambient temperature and humidity from a DHT sensor and prints both live on a 16x2 LCD, with an LED pair that flags when the reading crosses into fever range.

Hardware

A DHT sensor, an LCD, and two status LEDs on a breadboard.

The DHT module sits at the center of the breadboard, wired to an Arduino-compatible board running off USB power. A 16x2 LCD above it prints relative humidity and temperature directly, and a red and green LED pair, each behind a current-limiting resistor, give an at-a-glance status without reading the display.

Wiring schematic: DHT11 on D2, 16x2 I2C LCD on A4/A5, and red and green LEDs on D8/D9 through 220-ohm resistors
DHT11 → D2 · LCD I2C → A4/A5 · LEDs → D8/D9 via 220Ω.

How it works

The board polls the DHT sensor on an interval and writes the humidity and temperature straight to the LCD. Crossing the fever threshold swaps which LED is lit, so a glance at the breadboard is enough to tell a normal reading from a high one.

Next steps

The core read-and-display loop works on the breadboard. Next would be moving it off a breadboard onto a soldered perfboard, adding a buzzer for an audible alert, and logging readings over time instead of only showing the latest one.

Ready 準備完了4 sections